This stove can burn wood in a Smoke Control Area (most towns and cities are Smoke Control Areas).
call to preorder (including VAT)
This stove can burn wood in a Smoke Control Area (most towns and cities are Smoke Control Areas).
This stove can burn wood in a Smoke Control Area (most towns and cities are Smoke Control Areas)
This stove is certified as Ecodesign compliant (has passed the new and stringent 2022 regulations).
This stove is certified as Ecodesign compliant (has passed the new and stringent 2022 regulations)
Material: Steel with a cast-iron door
Output: 4.9kW
(max approx: 7kW)
Material: Steel with a cast-iron door
Output: 4.9kW
(max approx: 7kW)
Body
Width: 494mm
Height: 590mm
Depth: 314mm
Flue
5" (125mm)
Body
Width: 494mm
Height: 590mm
Depth: 314mm
Flue
5" (125mm)
Made in the UK
Big stove that fits into small spaces
Made in the UK
Big stove that fits into small spaces
The Parkray Aspect 5 Compact is the same as the Aspect 5 but has 5cm less depth and hence will stick out into the room just that little less. So no room to swing a cat (not a real one but an imitation) but you like a stove with a MASSIVE viewing window? Then this could be the stove for you.
And made in sunny Cornwall would you believe? Maybe Mr Poldark has one? He and Demelza might very well be curled up on a sheepskin rug as you read this, bare chest warming to flickering flame as we speak (his or hers your call).
Purchase one of these cracking stoves and we'll have it with you dreckly.
The Aspect 5 was Short-Listed for the Best Heating Category - House Beautiful Awards - 2017
Fill one of these monsters with wood and the kids will have no eyebrows left.
Wood only (multifuel with kit).
Nominal 4.9kW. Max. 7kW
This stove will run happily at 4kW - 7kW depending on fuel load. Note that running the stove at a higher fuel level than that specified in the manufacturer's manual may cause degradation of stove innards (firebricks, baffle etc.) although these are replaceable (and repairable with beige fire cement).
This stove meets and exceeds the new 2022 Ecodesign regulations
This stove is approved by DEFRA to burn wood in a Smoke Control Area
81.6% (as a rough guide 81.6% of heat goes to the room with 18.4% going up the chimney).
Don't overthink efficiency. 75%-85% is fine and 90%+ efficiency may not work so well on shorter or difficult chimneys.
No, this stove cannot be fitted with an external air kit (draws air from outside via pipe direct to stove). Usually this option is not relevant unless a room air-vent is required and the property is airtight (by design or choice).
See "Customers Also Bought".
Steel stove (10-year body guarantee) with cast-iron door
What to buy steel or cast-iron? Do not overthink. Steel heats fast. Cast-iron takes a little longer but retains heat longer as fire dies.
Hearth thickness: minimum 125mm non-combustible material (can include floor thickness).
Height: 590mm
Width: 494mm
Depth: 314mm
Front of pipe to rear of stove: 173mm
Flue outlet: 5" (125mm)
Which fitting pack for my liner? A fitting pack includes all you need except liner and chimney closure plate (also sometimes known as register plate)? Advice here
Viewing area (from outside stove looking in)
Width: TBC
Height: TBC
5" (125mm) collar top or rear (can be installed with a 5" or 6" chimney liner)
Top or rear connection
Distance to combustibles SIDE: 600mm
Distance to combustibles REAR: 200mm
To non-combustibles there are no hard rules but, around the stove, a 50mm minimum air gap is recommended to brick/stone. This to be increased to 100mm for rendered or boarded surfaces. Prior to purchasing any stove download the installation manual to check that manufacturers do not have any additional requirements.
Max Log Lenght: 350mm
We offer 14 days from delivery to report any courier damage to your stove. If a stove is damaged by the courier we will replace or refund as desired.
The manufacturer offers a 10 year body guarantee
Why do we sell glass insurance (pre-ticked box close to ADD TO CART button)? Because glass is classed, in the stoves industry, as a consumable item and not covered under ANY guarantee by any manufacture for any reason whatsoever. If it breaks or cracks on day one or day twenty it is not covered. If the inside of the glass goes cloudy or gets any kind of surface coating or etching then it is not covered (it will be to do with what you are burning according to manufacturers and glass makers). Glass usually costs £30-£60 plus postage but can be more on higher end models.
Defra-approved or/and Ecodesign stoves are designed and thoroughly tested before being allowed onto the market and every stove sold is identical. In the rare event a stove does not perform as well as expected it is always down to the installation, the chimney or circumstances unique to the property (pressure imbalances caused by local conditions, down drafts etc.). Here at Stovefitter's we have taken stoves back on a number of occasions for testing on our chimney and in every situation the stoves performed as expected (we may of course find a faulty stove one day but never as yet). We may, at our discretion, take a stove back once it has been used and in this situation a 50% refund would be provided (stove would be sold as second hand). We would, however, offer a 33% refund on a replacement stove.
Already have a chimney? You need 1. Stove 2. Liner 3. Fitting Pack 4. Chimney closure plate (Hardiebacker board from Builder's merchants or galvanised sheet).That's it!
No chimney? Check out our shed kits or let us design your clip-together chimney design - easy peasy.
Stovefitter's Warehouse is owned and managed by Julian Patrick, blogger and author of The Stove Fitter's Manual. Julian was previously a full-time installer of wood-burning stoves (including solid fuel heating systems). He laid down the tools in 2013 to write his stove manual and open a small shop in North Wales (the Wood Stove Hut, soon to grow into The Stovefitter's Warehouse).